https://github.com/meshtastic/device-ui/issues/102

I’m digging it. Especially the virtual node I can connect multiple things to

This is awesome to hear. Fingers crossed that mine continues to bloom consistently. I’m pretty OK with the green-yellow color and if they start to redden more then, cool. Just being happy with what I’ve got because any bloom at all is apparently pretty rare 🥰

Me either!

Try running ‘meshmonitor’. It’ll keep a history for you.

Is your coax TV/video coax? If so, be careful with that because the impedance is likely 75ohm and your HT very likely expects 50ohm. How big of a problem that is is up to you to research/decide.

If you don’t have appropriate coax some things you could try:

• Adding a tiger tail to the existing antenna (assuming you could reassemble it)

• getting higher up

• If you can’t reassemble the OG antenna, use the connector and solder the dipole radiators to it directly

Location report accuracy is configured via channel options

Plug the antenna into a tinyvna?

So long as one of the presets is the primary channel all messages share the same frequency and airtime. Add secondary channels doesn’t do anything to lower utilization of the defaults so long as they remain the primary channel.

In st. louis there’s #MeshSTL but it doesn’t have open encryption and still uses the LongFast slot. I don’t buy the politeness argument and all the meshes around here that are getting high air time are just moving to LongTurbo entirely.

Buy any pi meshtastic hat (good luck finding one in stock), install meshtastic daemon, profit?